LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 975 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Column Trim Covers Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  2. Remove the steering wheel from the column. Refer to Steering Wheel Replacement .
  3. Remove the tilt lever from the lower trim cover. Refer to Tilt Lever Replacement .
  4. If necessary, remove the 2 pan head tapping screws (1, 2) from the lower trim cover (3). Remove the lower trim cover (3).

    If screws are not present in the lower trim cover, proceed to the next step.

    Fig 1: View Of Lower Trim Cover Assembly
    GM692091Courtesy of GENERAL MOTORS CORP.
  5. Gently unsnap the lower trim cover from the upper trim cover.
    Fig 2: View Of Lower Trim Cover At Upper Trim Cover
    GM723623Courtesy of GENERAL MOTORS CORP.
    6. IMPORTANT: You must check for 1 pan head tapping screw (1) in the upper trim cover (2) before removal.
    Fig 3: View Of TORX(R) Head Screw & Upper Trim Cover
    GM692093Courtesy of GENERAL MOTORS CORP.
  6. If necessary, remove 1 TORX® head screw (1) from the upper trim cover (2).

    If a screw is not present, remove the upper trim cover (2).

scientia non olet · About LEMON Manuals