Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the shift lever (1).

Fig 1: Installing The Shift Lever (Without Tow/Haul Switch)
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the TORX® head shift lever screw (2).
Tighten: Tighten the screw to 20 N.m.
Roll the seal over the TORX® head shift lever screw (2).