LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 975 (Steering Wheel And Steering Column) >> Repair Instructions >> Shift Lever Replacement (With Tow/Haul Switch) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the trim covers. Refer to Steering Column Trim Covers Replacement .
  2. Roll back the seal on the shift lever (1) until the TORX® head shift lever screw (2) is exposed.
  3. Remove the TORX® head shift lever screw (2).
    Fig 1: Locating Seal On The Shift Lever And TORX® Head Shift Lever Screw (With Tow/Haul Switch)
    GM362445Courtesy of GENERAL MOTORS CORP.
  4. Remove the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
  5. Remove the nuts (1) from the knee bolster deflector bracket.
    Fig 2: Removing Nuts From The Knee Bolster Deflector Bracket (With Tow/Haul Switch)
    GM748879Courtesy of GENERAL MOTORS CORP.
    6. NOTE: During removal of the steering column the wire harness retaining clip must be removed and reinstalled after installing the steering column or damage may occur to the wire harness.
    Fig 3: Removing Wiring Harness Retaining Pin From The Instrument Panel (With Tow/Haul Switch)
    GM748881Courtesy of GENERAL MOTORS CORP.
  6. Remove the wiring harness retaining pin (4) from the instrument panel.
  7. Remove the wire straps and open the harness insulation to gain access to the electrical wiring.
  8. Remove the wiring from the electrical connector.
  9. Remove the shift lever.
scientia non olet · About LEMON Manuals