LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 975 (Steering Wheel And Steering Column) >> Repair Instructions >> Ignition Lock Cylinder Case Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  2. Remove the ignition switch. Refer to Ignition Switch Replacement .
  3. Remove the turn signal cancel cam. Refer to Steering Column Tilt Head Housing Replacement (Tilt)  or Steering Column Tilt Head Housing Replacement (Standard) .
  4. Remove the park lock cable from the lock cylinder housing.
  5. Remove 3 TORX® screws.
    Fig 1: View Of Lock Cylinder Housing TORX Screws
    GM1413838Courtesy of GENERAL MOTORS CORP.
  6. Remove the lock cylinder housing from the steering column.
scientia non olet · About LEMON Manuals