Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 1: View Of Lock Cylinder Housing TORX Screws

Courtesy of GENERAL MOTORS CORP.

Install 3 TORX® screws into the lock cylinder housing.
Tighten: Tighten the TORX® screws to 7 N.m (62 lb in).
Install the turn signal cancel cam. Refer to Steering Column Tilt Head Housing Replacement (Tilt) or Steering Column Tilt Head Housing Replacement (Standard) .
Install the park lock cable into the lock cylinder housing.
Install the ignition switch. Refer to Ignition Switch Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.