LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 974 (Engine Controls - 8.1L (Introduction)) >> Repair Instructions >> Fuel Pressure Dampener Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure .
    Fig 1: View Of Fuel Damper
    GM1254422Courtesy of GENERAL MOTORS CORP.
  2. Remove the engine sight shield. Refer to Engine Sight Shield Replacement in Engine Mechanical - 8.1L.
  3. Clean any dirt from the fuel pressure dampener retainer and the surrounding area.
  4. Remove the fuel pressure dampener clip (1) and dampener.
    5. Fig 2: View Of Fuel Pressure Dampener Backup Ring
    GM1247853Courtesy of GENERAL MOTORS CORP.
  5. Remove the fuel pressure dampener backup ring.
    6. Fig 3: View Of Fuel Pressure Dampener O-Ring
    GM1247857Courtesy of GENERAL MOTORS CORP.
  6. Remove the fuel pressure dampener O-ring.
scientia non olet · About LEMON Manuals