LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 974 (Engine Controls - 8.1L (Introduction)) >> Repair Instructions >> Filler Tube Replacement (Cab/Chassis - Rear) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Fill Pipe Assembly (Cab/Chassis - Rear)
    GM1228175Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel fill and vent hoses to the tank.
  2. Tighten the fuel vent pipe hose clamp (1) at the tank.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the fuel fill pipe hose clamp (2) at the tank.

    Tighten:  Tighten the clamps to 2.5 N.m (22 lb in).

scientia non olet · About LEMON Manuals