LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 974 (Engine Controls - 8.1L (Introduction)) >> Repair Instructions >> Filler Tube Replacement (Cab/Chassis - Front) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. If equipped with a rear auxiliary tank, disconnect the fuel and evaporative emission (EVAP) quick connect fittings. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
    Fig 1: View Of Fuel Feed And Pressure Balance Lines
    GM1228187Courtesy of GENERAL MOTORS CORP.
  2. Cap the fuel feed and EVAP pipes in order to prevent possible system contamination.
    3. Fig 2: View Of Fuel Fill Pipe Clamp & Vent Pipe Clamp
    GM1228174Courtesy of GENERAL MOTORS CORP.
  3. Loosen the fuel fill pipe clamp (2) at the tank.
  4. Loosen the vent pipe clamp (1) at the tank.
  5. Remove the fuel fill pipe and vent pipe from the tank.
  6. Cap the fuel and vent openings in the tank in order to prevent possible system contamination.
scientia non olet · About LEMON Manuals