LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 974 (Engine Controls - 8.1L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the EVAP canister purge valve.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: EVAP Canister Purge
    GM858210Courtesy of GENERAL MOTORS CORP.
  2. Install the EVAP canister purge valve bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: View Of EVAP Purge Tube At Purge Solenoid
    GM843915Courtesy of GENERAL MOTORS CORP.
  3. Connect the EVAP purge tube to the purge solenoid.
    4. Fig 3: View Of Generator, Injector Harness, Ignition Coil Harness, ETC & Purge Valve Solenoid Electrical Connectors
    GM1235689Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP canister purge valve electrical connector (1).
  5. Install the engine sight shield. Refer to Engine Sight Shield Replacement in Engine Mechanical - 8.1L.
scientia non olet · About LEMON Manuals