Installation Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure that the NEW fuel pressure regulator retainer is the correct one.
- The tab (1) is used on the E85-straight vacuum port retainer (3).
- Install the following parts onto the fuel pressure regulator (9), if necessary.
- Backup ring (10)
- Regulator seal O-ring (11)
- Regulator filter (12)
- Regulator seal O-ring (13)
- Lubricate the fuel pressure regulator O-rings (11, 13) with clean engine oil.
- Install the fuel pressure regulator (9).IMPORTANT: Whenever the fuel pressure regulator is removed from the fuel rail NEW O-rings and a NEW retaining clip should be used on reinstallation.
- Install the NEW fuel pressure regulator retainer (8).
- Install the fuel pressure regulator vacuum hose.
- Install the fuel fill cap.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical.
- Use the following procedure in order to inspect for leaks:
- Turn the ignition ON, with the engine OFF, for 2 seconds.
- Turn the ignition OFF for 10 seconds.
- Turn the ignition ON, with the engine OFF.
- Inspect for fuel leaks.