LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 973 (Engine Controls - 4.8L, 5.3L, & 6.0L (Introduction)) >> Repair Instructions >> Filler Tube Replacement (Cab/Chassis - Rear) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fuel fill and vent hoses to the tank.
  2. Tighten the fuel vent pipe hose clamp (1) at the tank.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the fuel fill pipe hose clamp (2) at the tank.

    Tighten:  Tighten the clamps to 2.5 N.m (22 lb in).

    4. Fig 1: Fuel Fill Pipe Hose Clamp & Fuel Vent Pipe Hose Clamp
    GM1228175Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals