LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 973 (Engine Controls - 4.8L, 5.3L, & 6.0L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement (Cab/Chassis) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the EVAP CVS valve line to the CVS, if necessary.
  2. Install the CVS valve and line.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the EVAP CVS valve bracket bolt (1).

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

    4. Fig 1: EVAP Line At Clips On Fuel Tank
    GM1228184Courtesy of GENERAL MOTORS CORP.
  4. Install the EVAP CVS line to the clips on the fuel tank.
  5. Connect the EVAP CVS electrical connector (1).
    6. Fig 2: CVS Electrical Connector (Cab/Chassis)
    GM1238187Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals