LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 973 (Engine Controls - 4.8L, 5.3L, & 6.0L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement (1500 Crew Cab) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the canister vent solenoid (CVS) electrical connector (1).
    3. Fig 1: CVS Electrical Connector (1500 Crew Cab)
    GM1238181Courtesy of GENERAL MOTORS CORP.
  3. Remove the CVS bracket bolt.
  4. Disconnect the CVS line from the evaporative emission (EVAP) canister. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  5. Remove the CVS from the vehicle.
    6. Fig 2: CVS (1500 Crew Cab)
    GM1223732Courtesy of GENERAL MOTORS CORP.
  6. If necessary, remove the CVS from the CVS bracket.
scientia non olet · About LEMON Manuals