LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 973 (Engine Controls - 4.8L, 5.3L, & 6.0L (Introduction)) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the CKP sensor.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CKP sensor bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    3. Fig 1: CKP Sensor & Bolt
    GM1239292Courtesy of GENERAL MOTORS CORP.
  3. Connect the CKP sensor electrical connector.
    4. Fig 2: View Of CKP Sensor Electrical Connector
    GM1236361Courtesy of GENERAL MOTORS CORP.
  4. Install the starter. Refer to Starter Motor Replacement (4.3L Engine) or Starter Motor Replacement (4.8L, 5.3L, and 6.0L Engines) or Starter Motor Replacement (6.6L (LB7) Engine) or Starter Motor Replacement (6.6L (LLY) Engine) or Starter Motor Replacement (8.1L Engine) in Engine Electrical.
  5. Perform the CKP system variation learn procedure. Refer to CKP System Variation Learn Procedure .
scientia non olet · About LEMON Manuals