LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 965 (Manual Transmission -- ZF S6-650) >> Repair Instructions >> Vehicle Speed Sensor (VSS) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate a NEW O-ring seal with transmission fluid.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the VSS and bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    Fig 1: Installing The VSS
    GM690158Courtesy of GENERAL MOTORS CORP.
    3. Fig 2: Connecting The VSS Electrical Connector (8.1L Engine)
    GM776054Courtesy of GENERAL MOTORS CORP.
  3. If equipped with the 8.1L engine, connect the VSS electrical connector (5).
    4. Fig 3: Connecting The VSS Electrical Connector (6.6L Engine)
    GM776052Courtesy of GENERAL MOTORS CORP.
  4. If equipped with the 6.6L engine, connect the VSS electrical connector (4).
  5. Lower the vehicle.
  6. Check the transmission fluid level. Add if necessary.
scientia non olet · About LEMON Manuals