LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 965 (Manual Transmission -- ZF S6-650) >> Repair Instructions >> Transmission Mount Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Broken or deteriorated mounts can cause misalignment and destruction of certain drive train components. When a single mount breaks, the remaining mounts are subjected to abnormally high stresses.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the transmission mount to crossmember nuts.
    Fig 1: Removing The Transmission Mount Fasteners
    GM691715Courtesy of GENERAL MOTORS CORP.
  3. Remove the transmission mount bolts to the transmission.
  4. Raise the transmission using a suitable transmission jack, just enough in order to permit the removal of the mount.
  5. Remove the transmission mount.
scientia non olet · About LEMON Manuals