LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 965 (Manual Transmission -- ZF S6-650) >> Repair Instructions >> Transmission Input Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the NEW seal in the front case with the part number facing out.
    Fig 1: Positioning The New Seal In The Front Case
    GM694468Courtesy of GENERAL MOTORS CORP.
  2. Using J 44731  install the input shaft seal.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 2: Installing The Clutch Actuator Cylinder
    GM689675Courtesy of GENERAL MOTORS CORP.
  3. Position the clutch actuator cylinder.
  4. Install the clutch actuator cylinder bolts.

    Tighten:  Tighten the bolts to 8 N.m (71 lb in).

  5. Install the transmission. Refer to Transmission Replacement .
  6. Install the rear propeller shaft. Refer to Propeller Shaft Replacement - One Piece or Propeller Shaft Replacement - Two Piece in Propeller Shaft.
  7. Check the transmission fluid level. Add if necessary.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals