Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Coat the NEW O-ring seal with a thin film of transmission fluid, use GM P/N 12346190 (Canadian P/N 10953477), or equivalent.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the VSS.

Fig 1: Installing The VSS
Courtesy of GENERAL MOTORS CORP.

Tighten: Tighten the VSS to 16 N.m (12 lb ft).

Fig 2: Connecting The VSS Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the VSS electrical connector (3).
Lower the vehicle.