LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 964 (Manual Transmission -- NV 4500) >> Repair Instructions >> Transmission Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the transmission mount.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the transmission mount to transmission bolts.

    Tighten:  Tighten the transmission mount bolts to 50 N.m (37 lb ft).

    Fig 1: Installing The Transmission Mount To Transmission Bolts
    GM772345Courtesy of GENERAL MOTORS CORP.
  3. Lower the transmission and remove the transmission jack.
    4. Fig 2: Installing The Transmission Mount To Crossmember Nut
    GM775038Courtesy of GENERAL MOTORS CORP.
  4. Install the transmission mount to crossmember nut.

    Tighten:  Tighten the transmission mount to crossmember nut to 40 N.m (30 lb ft).

  5. Lower the vehicle.
scientia non olet · About LEMON Manuals