LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 964 (Manual Transmission -- NV 4500) >> Repair Instructions >> Transmission Housing Oil Seal Replacement - Rear (2WD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using J 22834-A  install the NEW rear oil seal.
    Fig 1: Installing The New Rear Oil Seal (2WD)
    GM789447Courtesy of GENERAL MOTORS CORP.
  2. If required, install the following:
    1. The yoke
    2. A NEW main shaft washer
    3. A NEW prop shaft yoke washer
    4. The main shaft nut
    Fig 2: Installing Propeller Shaft Yoke (2WD)
    GM775218Courtesy of GENERAL MOTORS CORP.
  3. If required, use J 8614-01  in order to keep the keep yoke from rotating.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Tighten the main shaft nut.

    Tighten:  Tighten the nut to 441 N.m (325 lb ft).

    Fig 3: Tightening The Main Shaft Nut (2WD)
    GM727452Courtesy of GENERAL MOTORS CORP.
  5. Install the rear propeller shaft. Refer to Propeller Shaft Replacement - One Piece or Propeller Shaft Replacement - Two Piece in Propeller Shaft.
  6. Check the transmission fluid level. Add if necessary.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals