Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Apply a thin bead of sealant GM P/N 12346004 (Canadian P/N 10953480), or equivalent to the oil drain and fill plug threads.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the oil drain plug.
Tighten: Tighten the plug to 37 N.m (27 lb ft).

Fig 1: Installing The Oil Drain Plug
Courtesy of GENERAL MOTORS CORP.

Fig 2: Checking Transmission Fluid Level

Courtesy of GENERAL MOTORS CORP.

Fill the transmission to just below the bottom of the fill plug hole. Refer to Lubrication Specifications .

Fig 3: Installing The Oil Fill Plug

Courtesy of GENERAL MOTORS CORP.

Install the oil fill plug.
Tighten: Tighten the plug to 37 N.m (27 lb ft).
Lower the vehicle.