LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 964 (Manual Transmission -- NV 4500) >> Repair Instructions >> Shift Lever Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • Ensure that the control lever is positioned into the mechanical third or fourth gear prior to removal of the shift lever from the transmission. The transmission must remain in this state when the shift lever is removed.
  • Do not disassemble the transmission shift lever. Internal parts for this shift lever are not available. Opening the shift housing lever voids the warranty.
  • When removing the shift lever from the transmission, use the exposed bolts on the base of the lever.
  1. Remove the control lever and boot. Refer to Control Lever and/or Boot Replacement .
  2. Remove the transmission support. Refer to Transmission Support Replacement in Frame and Underbody.
  3. Lower the transmission slightly to access to insulator.
  4. Cut one side of the insulator in order to remove it. Remove the insulator.
    Fig 1: Removing The Shift Lever And Seal
    GM178851Courtesy of GENERAL MOTORS CORP.
  5. Remove the shift lever and seal.
scientia non olet · About LEMON Manuals