LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 964 (Manual Transmission -- NV 4500) >> Repair Instructions >> Shift Lever Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shift lever seal and lever.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Installing The Shift Lever Seal And Lever
    GM178851Courtesy of GENERAL MOTORS CORP.
  2. Install the shift lever bolts.

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

  3. Install the insulator.
  4. Raise the transmission.
  5. Install the transmission support. Refer to Transmission Support Replacement in Frame and Underbody.
  6. Install the control lever and boot. Refer to Control Lever and/or Boot Replacement .
scientia non olet · About LEMON Manuals