LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 964 (Manual Transmission -- NV 4500) >> Repair Instructions >> Backup Lamp Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure the seal is installed on the switch.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the backup lamp switch.

    Tighten:  Tighten the switch to 28 N.m (21 lb ft).

    Fig 1: Installing The Backup Lamp Switch
    GM761120Courtesy of GENERAL MOTORS CORP.
    3. Fig 2: Connecting The Backup Lamp Switch Electrical Connector
    GM775031Courtesy of GENERAL MOTORS CORP.
  3. Connect the backup lamp switch electrical connector (1).
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals