LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 963 (Manual Transmission -- NV 3500) >> Repair Instructions >> Transmission Housing Oil Seal Replacement - Rear (2WD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using J 36503  install the NEW rear oil seal.
    Fig 1: Installing The New Rear Oil Seal
    GM548114Courtesy of GENERAL MOTORS CORP.
  2. Install the rear propeller shaft. Refer to Propeller Shaft Replacement - One Piece or Propeller Shaft Replacement - Two Piece in Propeller Shaft.
  3. Check to transmission fluid level. Add if necessary.
  4. Lower the vehicle.