Diagnostic Aids
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Separate the EBCM from the BPMV in order to inspect for corrosion or any other condition that may cause a poor connection at the pump motor connector. Refer to Electronic Brake Control Module Replacement and Testing for Intermittent Conditions and Poor Connections . If severe corrosion or other damage exists, the BPMV or the EBCM may need to be replaced.
DTC C0110
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: ABS Schematics Connector End View Reference: ABS Connector End Views |
|||
| 1 | Did you perform the ABS Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - ABS |
| 2 | Use a scan tool in order to clear the DTCs. Does the DTC reset? |
Go to Step 3 | Go to Diagnostic Aids |
| 3 |
|
Go to Step 5 | Go to Step 4 |
| 4 |
IMPORTANT:
Following EBCM replacement, use the scan tool to perform the Tire Size Calibration procedure. Replace the EBCM and the BPMV. Refer to Electronic Brake Control Module Replacement and Brake Pressure Modulator Valve (BPMV) Replacement .Did you complete the replacements? |
Go to Step 5 | - |
| 5 |
|
Go to Step 3 | System OK |