LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 959 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Rear Quarter (Crew Cab) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat belt through the trim panel.
  2. Install the quarter panel.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the lower seat belt anchor bolt.

    Tighten:  Tighten the bolt to 53 N.m (39 lb ft).

  4. Install the quarter panel trim screws.

    Tighten:  Tighten the quarter panel trim screws to 2 N.m (18 lb in).

    5. Fig 1: Installing Rear Quarter Trim Panel (Crew Cab)
    GM623039Courtesy of GENERAL MOTORS CORP.
  5. Install the rear window lower molding. Refer to Molding Replacement - Rear Window Lower  .
  6. Install the coat hook, if removed. Refer to Coat Hook Replacement  .
scientia non olet · About LEMON Manuals