Installation Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the carpet to the vehicle.
- Install the lower bolt to the I/P support post. Refer to Instrument Panel (I/P) Carrier Replacement in Instrument Panel, Gages and Console.
- Install the rear quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter (Regular Cab) , Trim Panel Replacement - Rear Quarter (Extended Cab) or Trim Panel Replacement - Rear Quarter (Crew Cab) .
- Install the jack assembly.
- Install the energy storage box. Refer to Energy Storage Box (ESB) Carrier Replacement (5.3L Engine w/RPO HP2) in Engine Electrical.
- Install the rear seat if removed. Refer to Seat Replacement - Rear (Extended Cab w/4th Door) , Seat Replacement - Rear (Extended Cab) or Seat Replacement - Rear (60/40 Split) in Seats.
- Install the center seat, if equipped. Refer to Seat Replacement - Center in Seats.
- Install the floor console. Refer to Console Replacement (w/Console Mounting Bracket) or Console Replacement (w/o Console Mounting Bracket) .
- Install the front seats. Refer to Seat Replacement - Front Bucket in Seats.
- Install the door sill plates. Refer to Door Sill Plate Replacement - Front or Door Sill Plate Replacement - Rear .
- Install the hinge pillar trim panel. Refer to Trim Panel Replacement - Hinge Pillar .
CAUTION:
In order to avoid personal injury or vehicle damage when you repair or replace the carpet, use the same thickness and material size as the original installation. Always return the carpet to the original location.