Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the assist handle to the vehicle.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the assist handle screws.
Tighten: Tighten the screws to 6 N.m (53 lb in).

Fig 1: Installing Rear Assist Handle

Courtesy of GENERAL MOTORS CORP.

Install the center pillar trim panel. Refer to Garnish Molding Replacement - Center Pillar .