LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Switch Replacement - Hot and Cold Cupholder >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cupholder assembly. Refer to Cupholder Replacement (Luxury) , Cupholder Replacement (Non-Luxury) , Cupholder Replacement (Rear)  or Cupholder Replacement (Pro) .
    2. IMPORTANT: Observe the orientation of the switches. The red lights points towards the rear of the vehicle.
  2. Disconnect the wire connectors from the 2 switches.
    • Switch 1 is the power switch.
    • Switch 2 is the hot and cold switch.
    3. Fig 1: Hot & Cold Cupholder Switches
    GM824844Courtesy of GENERAL MOTORS CORP.
  3. Remove the defective switch by pushing in the retaining tabs (1) while pushing the switch outwards.
    4. Fig 2: Hot & Cold Cupholder Switch Retaining Tabs
    GM824839Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals