LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Knee Bolster Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Snap the top of the knee bolster into the I/P assembly.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the knee bolster screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    3. Fig 1: Installing Knee Bolster
    GM348714Courtesy of GENERAL MOTORS CORP.
  3. Install the I/P cluster trim plate bezel. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster .
scientia non olet · About LEMON Manuals