LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Instrument Panel (I/P) Harness Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the I/P harness to the vehicle.
  2. Install the harness grommet to the cowl.
  3. Connect the wire harness to the hood, if equipped with underhood camp.
    4. Fig 1: I/P Harness
    GM603160Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical harness from the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement .
  5. Install the driver's side seat, if equipped with power. Refer to Seat Replacement - Front Bucket
  6. Install the driver's side hinge pillar trim panel. Refer to Trim Panel Replacement - Hinge Pillar .
  7. Install the I/P carrier. Refer to Instrument Panel (I/P) Carrier Replacement .
scientia non olet · About LEMON Manuals