LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Instrument Cluster Lamp Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: This procedure calls for the replacement of incandescent bulbs only. The light emitting diodes (LEDs) are not replaceable individually. If LED replacement is needed, send the cluster to an AC Delco Service Center. Refer to Instrument Panel Cluster (IPC) Replacement .
  1. Remove the instrument panel (IP) cluster. Refer to Instrument Panel Cluster (IPC) Replacement .
  2. Unclip the IP cluster rear cover plate by prying gently on the tabs with a screwdriver.
    3. Fig 1: Unclipping IPC Rear Cover Plate
    GM367197Courtesy of GENERAL MOTORS CORP.
  3. Remove the rear cover plate from the IP cluster.
    4. Fig 2: IPC Rear Cover Plate
    GM348651Courtesy of GENERAL MOTORS CORP.
  4. Remove the bulb and base assembly by turning the bulb 1/2 turn counter clockwise and pulling outward.
    5. Fig 3: Turning IPC Bulb
    GM368778Courtesy of GENERAL MOTORS CORP.
  5. Remove the bulb from the base by pulling outward.
scientia non olet · About LEMON Manuals