LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Cupholder Replacement (Pro) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the beverage-mate to the cupholder.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the retaining screws.

    Tighten:  Tighten the retaining screws to 1.6 N.m (14 lb in).

    3. Fig 1: Cupholder (Pro)
    GM824846Courtesy of GENERAL MOTORS CORP.
  3. Install the switches to the cupholder assembly. Refer to Switch Replacement - Hot and Cold Cupholder .
  4. Connect the wire connectors to the switches.
  5. Install the cupholder assembly to the console by pressing downwards until fully seated.
scientia non olet · About LEMON Manuals