LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Console Storage Bin Replacement (Pro) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the console bin and lid assembly over the console in order to route the electrical cord to the console bin.
  2. Install the console bin and lid assembly to the console.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    3. IMPORTANT: Ensure the rear bolts has the bigger washer.
  3. Install the 4 console bin retaining bolts (1).

    Tighten:  Tighten the 4 bolts to 3.5 N.m (35 lb in).

    4. Fig 1: Installing Console Storage Bin Bolts (Pro)
    GM824838Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure the longer screw is installed in the front of the console bin.
  4. Install the 6 retaining screws (1).

    Tighten:  Tighten the 6 screws to 1.6 N.m (14 lb in).

    5. Fig 2: Installing Console Storage Bin Lid Screws (Pro)
    GM824843Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals