LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Console Replacement (w/Console Mounting Bracket) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove both front seats. Refer to Seat Replacement - Front Bucket in Seats.
  2. If equipped with a Bose® amplifier, remove the radio amp fuse located under the hood electrical center. Refer to Electrical Center Identification Views in Wiring Systems.
  3. Remove the upper console bezel. Refer to Bezel Replacement - Floor Console (Non-Luxury Upper) , Bezel Replacement - Floor Console (Luxury Upper)  or Bezel Replacement - Floor Console (Non-Luxury Lower) .
  4. Remove the cupholder. Refer to Cupholder Replacement (Luxury) , Cupholder Replacement (Non-Luxury) , Cupholder Replacement (Rear)  or Cupholder Replacement (Pro) .
  5. Remove the screws (1) retaining the console to the I/P.
    6. Fig 1: Identifying Bolts Retaining Console To Instrument Panel
    GM854810Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the wire connectors.
  7. Remove the console assembly from the vehicle.
  8. Remove the rear seat audio control from the console, if equipped. Refer to Audio Control Replacement - Rear Seat in Entertainment.
scientia non olet · About LEMON Manuals