LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Console Replacement (w/Console Mounting Bracket) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear seat audio control to the console, if equipped. Refer to Audio Control Replacement - Rear Seat in Entertainment.
  2. Install the console in the vehicle.
  3. Connect the wire connectors.
  4. Move the console forward in order to install the retaining screws.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the 2 screws (1).

    Tighten:  Tighten the screws to 4 N.m (35 lb in).

    6. Fig 1: Identifying Bolts Retaining Console To Instrument Panel
    GM854810Courtesy of GENERAL MOTORS CORP.
  6. Install the cupholder to the console. Refer to Cupholder Replacement (Luxury) , Cupholder Replacement (Non-Luxury) , Cupholder Replacement (Rear)  or Cupholder Replacement (Pro) .
  7. Install the upper console bezel. Refer to Bezel Replacement - Floor Console (Non-Luxury Upper) , Bezel Replacement - Floor Console (Luxury Upper)  or Bezel Replacement - Floor Console (Non-Luxury Lower) .
  8. Install the radio amp fuse, if removed. Refer to Electrical Center Identification Views in Wiring Systems.
  9. Install both front seats. Refer to Seat Replacement - Front Bucket in Seats.
scientia non olet · About LEMON Manuals