LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Center Console End Panel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the storage bin. Refer to Console Storage Bin Replacement (Expect Pro)  or Console Storage Bin Replacement (Pro) .
  2. Remove the rear cupholder from the end panel. Refer to Cupholder Replacement (Luxury) , Cupholder Replacement (Non-Luxury) , Cupholder Replacement (Rear)  or Cupholder Replacement (Pro) .
  3. Remove the 2 retaining screws.
    4. Fig 1: Cupholder Screws
    GM882669Courtesy of GENERAL MOTORS CORP.
  4. Remove the top 2 retaining screws.
    5. Fig 2: End Panle Upper Screws
    GM882652Courtesy of GENERAL MOTORS CORP.
  5. Move the end panel rearwards to gain access to the electrical connectors.
  6. Remove the end panel from the console.
  7. Remove the rear seat heater switch, if equipped. Refer to Heated Seat Switch Replacement - Rear in Seats.
  8. Remove the rear seat audio controls, if equipped. Refer to Audio Control Replacement - Rear Seat in Entertainment.
  9. Remove the power outlets from the end panel, if equipped. Refer to Accessory Power Receptacle Replacement - 12 Volt in Power Outlets.
scientia non olet · About LEMON Manuals