LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Center Console End Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power outlets to the end panel, if equipped. Refer to Accessory Power Receptacle Replacement - 12 Volt in Power Outlets.
  2. Install the rear seat audio control, if equipped. Refer to Audio Control Replacement - Rear Seat in Entertainment.
  3. Install the rear seat heater switch, if equipped. Refer to Heated Seat Switch Replacement - Rear in Seats.
  4. Connect all electrical connectors.
  5. Install the end panel to the console.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the 2 top retaining screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

    7. Fig 1: End Panel Upper Screws
    GM882652Courtesy of GENERAL MOTORS CORP.
  7. Install the 2 retaining screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

    Fig 2: Cupholder Screws
    GM882669Courtesy of GENERAL MOTORS CORP.
  8. Install the rear cupholder to the end panel. Refer to Cupholder Replacement (Luxury) , Cupholder Replacement (Non-Luxury) , Cupholder Replacement (Rear)  or Cupholder Replacement (Pro) .
  9. Install the storage bin. Refer to Console Storage Bin Replacement (Expect Pro)  or Console Storage Bin Replacement (Pro) .
scientia non olet · About LEMON Manuals