LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 956 (Entertainment System) >> Repair Instructions >> Speaker Replacement - Front Floor Console (Subwoofer Speaker) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the speaker into the subwoofer assembly.
  2. Fig 1: Installing The Speaker Into The Subwoofer Assembly
    GM882647Courtesy of GENERAL MOTORS CORP.
  3. Connect the wire connector.
  4. NOTE: Refer toFastener Notice in Cautions and Notices.
  5. Install the 4 retaining screws.

    Ensure the screw follows the same thread in the screw boss so that a new thread is not formed.

    Tighten:  Tighten the screws to 6 N.m (53 lb in).

  6. Move the console forward in order to connect the wire connector.
  7. Install the console to the I/P. Refer to Console Replacement (w/Console Mounting Bracket) or Console Replacement (w/o Console Mounting Bracket) in Instrument Panel, Gages and Console.
  8. Install the 2 front seats. Refer to Seat Replacement - Front Bucket in Seats.