Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Components of the DVD player cannot be serviced separately. Replace as an assembly.

Fig 1: Locating DVD Player Front Retaining Bolts

Courtesy of GENERAL MOTORS CORP.

Move the screen to the open position.
Remove the rear screw cover using a flat bladed tool.
Remove the four retaining bolts (2).
Insert the J 38778 between the headliner and the DVD player assembly.
With 1 hand holding the DVD player assembly, pry the retainer from the bracket.

Fig 2: View Of DVD Player Assembly

Courtesy of GENERAL MOTORS CORP.

Allow the DVD player assembly to come to rest on the hook.

Fig 3: Identifying DVD Player Wiring Harness & Connector

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Observe the routing of the wiring harness (2).

Disconnect the wire connector (1).
Slightly lift up the DVD player assembly so that the hook can be removed from its resting position.
Remove the DVD player from the vehicle.