LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 956 (Entertainment System) >> Repair Instructions >> Coaxial Cable Replacement - Digital Radio (Primary) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the windshield pillar garnish molding. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.
  2. Disconnect the XM radio antenna cable (1).
    Fig 1: Disconnecting The Xm Radio Antenna Cable (1)
    GM1207695Courtesy of GENERAL MOTORS CORP.
    3. NOTE: Use care when removing or installing the headliner. Excessive bending will damage the headliner.
  3. Lower the front of the headliner. Refer to Headliner Replacement in Interior Trim.
  4. Disconnect the XM antenna cable from the antenna connection above the headliner.
  5. Remove the cable clips from the windshield pillar and remove the antenna cable from the vehicle.
    Fig 2: Removing The Antenna Cable
    GM1207705Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals