LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 956 (Entertainment System) >> Repair Instructions >> Coaxial Cable Replacement - Digital Radio (Extension) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upper trim panel from the instrument panel (I/P). Refer to Trim Panel Replacement - Instrument Panel (I/P) Upper in Instrument Panel, Gages and Console.
  2. Disconnect the digital radio antenna cable (1).
    Fig 1: Disconnecting Digital Radio Antenna Cable (1)
    GM1207689Courtesy of GENERAL MOTORS CORP.
  3. Fully open the I/P storage compartment in order to access the digital receiver (3).
  4. Disconnect the antenna cable (2) from the digital receiver (3).
    Fig 2: Locating Digial Receiver
    GM1207701Courtesy of GENERAL MOTORS CORP.
  5. Disengage the antenna cable clips (4, 6) from the I/P.
  6. Remove the digital radio antenna extension cable (5).
scientia non olet · About LEMON Manuals