LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 955 (Door System, Mirror System & Window System) >> Repair Instructions >> Trim Panel Replacement - Side Rear Door (Crew Cab) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the door handle bezel. Refer to Handle Bezel Replacement - Inside .
  2. Remove the window-regulator handle, if equipped. Refer to Window Handle Replacement .
  3. Using a flat-bladed tool, remove the reflector lamp from the trim panel, and disconnect the electrical connector, if required.
  4. Remove the manual lock lever from the trim panel using a flat-bladed tool.
  5. Remove the two trim panel screws.
  6. Remove the trim panel from the door by carefully sliding the panel upward then outward.
    7. Fig 1: Removing Side Rear Door Trim Panel (Crew Cab)
    GM521846Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the electrical connectors.
scientia non olet · About LEMON Manuals