LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 955 (Door System, Mirror System & Window System) >> Repair Instructions >> Striker Replacement - Door >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: If both of the door striker bolts are removed at the same time, the striker backing plate will fall into the body. This will result in additional time to perform the repair.
  1. Remove the lower striker bolt.
  2. Loosen the upper striker bolt enough in order to rotate the striker and the spacer (if equipped) away from the lower bolt hole.
  3. Install the lower striker bolt. Tighten the lower striker bolt sufficiently in order to hold the striker backing plate in place.
  4. Remove the upper striker bolt.
  5. Remove the spacer, if equipped.
  6. Remove the striker.
    7. Fig 1: Removing Door Striker
    GM348470Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals