Removal Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Adjust the mirror face fully upward in order to access the mirror retaining tab (4).
- Position a flat-bladed tool between the back side of the mirror face and the mirror housing at the notch in the mirror face.
- Depress the tab (4) on the back of the mirror face outward using the flat-bladed tool, while sliding the mirror face upward.
- Slide the mirror face upward to release the mirror face from the mirror motor retaining tabs (1).
- With the mirror face in hand, disconnect the electrical connectors (2).
- Remove the mirror face from the mirror housing.
CAUTION:
When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.
NOTE:
When servicing electrochromic glass that is broken, or if glass breaks during servicing, be cautious not to spill electrochromic fluid onto vehicle. Doing so will cause damage to the vehicle.