LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 955 (Door System, Mirror System & Window System) >> Repair Instructions >> Lock Actuator Replacement - Rear Door >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the window.
  2. Remove the door trim panel. Refer to Trim Panel Replacement - Side Rear Door (Crew Cab) .
  3. Remove the water deflector. Refer to Water Deflector Replacement - Rear Door (Crew Cab) .
  4. Disconnect the inside door lock rod from the handle retainer clip.
    5. Fig 1: View Of Control Rod To Inside Door Handle
    GM348468Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the manual door lock rod from the door retainer clips.
    6. Fig 2: Disconnecting Manual Door Lock Rod From Retainer Clips
    GM348465Courtesy of GENERAL MOTORS CORP.
  6. Remove the rubber plug in order to disengage the outside handle rod retainer.
    7. Fig 3: Outside Handle Rod Retainer
    GM348463Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the cylinder lock rod (1).
  8. Remove the bolts (2) which retain the door lock actuator to the door.
    9. Fig 4: Cylinder Lock Rod & Door Lock Actuator Bolt
    GM800627Courtesy of GENERAL MOTORS CORP.
  9. Remove the door lock actuator and control rods as an assembly.
  10. Disconnect the electrical connector from the door lock actuator, if equipped.
  11. Remove the control rods as necessary.
scientia non olet · About LEMON Manuals