LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 955 (Door System, Mirror System & Window System) >> Repair Instructions >> Door Handle Replacement - Outside >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the trim panel. Refer to Trim Panel Replacement - Side Access Door .
  2. Remove the water deflector. Refer to Water Deflector Replacement - Front Door .
  3. Remove the outside handle rod from the rod clip.
    4. Fig 1: Removing Outside Handle Rod
    GM348458Courtesy of GENERAL MOTORS CORP.
  4. Remove the lock cylinder rod from the rod clip.
    5. Fig 2: Removing Lock Cylinder Rod
    GM348455Courtesy of GENERAL MOTORS CORP.
  5. Apply masking tape across the door handle on the outside of the door to secure handle while removing the nuts.
  6. Remove the outside handle mounting nuts.
  7. Remove the rubber cover in order to gain access to the outboard nut.
    8. Fig 3: Removing Rubber Cover
    GM373162Courtesy of GENERAL MOTORS CORP.
  8. Remove the door lock cylinder from the outside handle housing.

    In order to repair a binding lock cylinder, refer to Binding Lock Cylinders .

  9. Remove the handle.
    Fig 4: Removing Outside Handle
    GM348457Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals