LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 954 (Lighting Systems) >> Diagnostic Information and Procedures >> Roof Beacon Lamp Always On

Roof Beacon Lamp Always On

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Roof Beacon Lamp Always On

Step Action Yes No
Schematic Reference:  Upfitter Provision Schematics  in Wiring Systems
Connector End View Reference:  Lighting Systems Connector End Views  
1 Did you perform the Lighting Systems Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Lighting Systems 
2 Verify that the roof beacon lamp is always on.
Does the roof beacon lamp operate normally?
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3 Disconnect the roof beacon relay.
Does the roof beacon lamp turn off?
Go to Step 4  Go to Step 6 
4
  1. Reconnect the roof beacon relay.
  2. Disconnect the roof beacon switch.
Does the roof beacon lamp turn off?
Go to Step 7  Go to Step 5 
5 Test the hazard switch signal circuit of the roof beacon switch for a short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 9  Go to Step 8 
6 Repair the hazard flasher signal circuit of the roof beacon relay for a short to voltage. Refer to Wiring Repairs in Wiring Systems.
Did you complete the repair?
Go to Step 9  -
7 Replace the roof beacon switch.
Did you complete the replacement?
Go to Step 9  -
8 Replace the roof beacon relay. Refer to Relay Replacement (Within an Electrical Center) or Relay Replacement (Attached to Wire Harness) in Wiring Systems.
Did you complete the replacement?
Go to Step 9  -
9 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3