Test Description
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to the step numbers on the diagnostic table.
- 3: This step test determines if the problem exists in the wiring or the BCM.
- 5: After replacement of the BCM you must calibrate the new module for proper operation.
DTC B1480
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Interior Lights Schematics Connector End View Reference: Lighting Systems Connector End Views or Body Control System Connector End Views in Body Control System |
|||
| 1 | Did you perform the Lighting System Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Lighting Systems |
| 2 | Inspect the TBC 2C fuse in the I/P fuse block. Is the fuse open? |
Go to Step 3 | Go to Step 4 |
| 3 | Test the inadvertent power supply voltage circuit, and the TBC 2C battery supply voltage to the BCM for a short to ground. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 6 | Go to Step 4 |
| 4 | Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 6 | Go to Step 5 |
| 5 |
IMPORTANT:
Perform the setup procedure for the BCM. Replace the body control module (BCM). Refer to Body Control Module Replacement
in Body Control System.Did you complete the replacement? |
Go to Step 6 | - |
| 6 |
|
Go to Step 2 | System OK |